The Nissan Path

gilldawg79

Would this noise you are referring t kinda sound like a roaring noise that follows acceleration? As in, when you rev it up it gets louder?

gilldawg79

I am getting a P1031 code and a P1148 code. Closed loop bank 1. Which side of the vehicle is bank 1? I think this is the A/F sensor that is visible under the hood upstream of the cats? Is this the first thing to changeout? Or could it be something else? Should I stick with OEM or are there aftermark...

gilldawg79

I have a 2005 Pathy-101,015 miles. I got my code reader in today and I replaced my Fuel Sending Unit. I got one code cleared (P0463) by doing that. Codes remaining: P1148 (Closed Loop Bank 1--A/F sensor?) P1272 (Air Fuel Ratio Sensor -- Same thing???) P0171 (System too lean Bank 1 --A/F sensor ???) ...

gilldawg79

I will be going back to own oem. I did gap the non platinum plugs to 0.44. That was what the NGK website said , but according to that article sounded like non platin plugs should be gapped at .031-.035. I dont know. I was thinking that the O2 sensor could possibly be confused. Sounded like a bigger ...

gilldawg79

I would have to assume that the p in the part number is for platinum and those are what came our NOT what I put in. Should I go on and out the oe kind in. most definitely! http://www.se-r.net/engine/platinum_copper_ngk.html what a shame to have to do all that work over again :( So, according to tha...

gilldawg79

I would have to assume that the p in the part number is for platinum and those are what came our NOT what I put in. Should I go on and out the oe kind in. I have kept resetting the mpg gauge. I suppose I will stop resetting it and see where it goes from there. I will be ordering tje fuel sending uni...

gilldawg79

After driving it a good bit more, I can tell that something isn't quite right. It seems real rich smelling....So, I decided to look at the plugs that came out and the ones that went in.....The OE plugs were NGK PLFR5A-11's and I replaced them with NGK LFR5A-11's. According to NGK's website they are ...

gilldawg79

2005 Pathy XE 4X4. Changed plugs yesterday. 1st time in 100k miles. I noticed a significant performance change, but it seems as though my MPG's have gone down considerably. I removed intake to change 4-6 plugs. Gaskets looked good so I just reassembled. Prior to changing plugs I was averaging around...

gilldawg79

I did not have any problems. However, I have read many problems, not necessarily on this site, but other forums. Seems the most prominent problem was diagnosed as debris in a tranny after a flush in vehicles with high mileage and never being flushed earlier in life. Therefore, when it's flushed and ...

gilldawg79

I have an '05 Pathy bypassed at around 75K miles. I did a flush and fill at the dealer at around 55K miles. I just turned 100K this evening and wanted to see what you guys think. I have read some negative things about flushes, and since I have 100K miles on it, I am a little leery of a flush to be h...

gilldawg79

I always check my oil pressure at least once while driving wherever I am going, and as I was leaving the woods this afternoon I looked at my Oil Pressure gauge and it was pegged HIGH. I know that when I went to the woods it was operating normally. I turned the pathy off, and turned the key to on wit...

gilldawg79

There is a tranny high temp alarm light in the display...Does it work, I don't know, but it didn't light up.

gilldawg79

This weekend I towed my travel trailer 250 miles one way to Destin and back. Trailer loaded, car loaded, no issues. Pathy actually did better than I thought it would. I got 10 MPG, and averaged about 50 MPH. From where I live in West, central Alabama to Destin is almost all 2 lane, so the speed limi...

gilldawg79

Anybody have any good tips on installing the AirLift 1000's? I am planning on installing some in about a week or two and would like to know if there are any tips as to getting them in the spring. Actually, the ones I ordered only came with 2 protectors. The manual shows four. I called airlift and th...

gilldawg79

It's what streetrodders are using....Just google images "aluminum transmission cooler". Mounts on the frame anywhere airflow will be present....Ought to dissipate well.

Search found 25 matches

Two codes...A little help?

Codes read...1 fixed...4 to go. 2005 Pathy

Spark plug change...Better performance...Reduced MPG's

Tranny flush...to do or not to do?

Hi Oil Pressure..Sending Unit or Switch

Towed with a bypassed tranny cooler.....Good results

Installing Airlift 1000's (how to)

Nissan Forums

Infiniti Forums

Datsun Forums

Technical Forums

Classifieds / Marketplace

Nissan Motorsports

General Forums