The Nissan Path

Tech

yeah, i'm the same. Sometimes I feel guilty....I think my mod time is about equal to my riding time so far with this bike!

Forget the plugs....ride now, drive the truck when it rains!...

Tech

S models don't come with fogs....get the switch for any model than came with them, but without auto lights.

Tech

SPICOLI - I got myself and M90 last year, finally putting some seat time in this year....lovin it!

Tech

Sorry for the late reply, apparently the site has had some bandwidth issues...but as always, It's my pleasure!

I wouldn't bother with hotter or cooler. Just go for the regular.

Tech

plfr5a-11 NGK - i wouldn't use anything else 4a hotter 6a cooler Check the gap if you like, but don't try to regap. 0.043" Opinions vary, but i'd say remove the intake - not disassemble the coil and use swivels/extensions... also never-seize the threads (lightly) Good luck! Hows the riding?!

Tech

it's over $100 if i remember right. You also have to drill a couple holes in your frame and coat it with bitumen wax (also $$). If it were me, i'd drop the canister and valve (1 bolt, few hoses, one electrical connector) and check for mud debris first. There is an updated VCV. It's totally different...

Tech

it's your vent control valve. you may also need an auxilary filter kit installed if your vehicle didn't come with one. You may also want to drop your canister and check to see if its packed with mud (inside). Best case, you can clean it out and be ok worst; VCV, cannister and filter kit (pain to ins...

Tech

On the back of the tcase, where the big solenoid is....if you get particulate matter in there, and/or water you can have electrical issues. Glad it's warranty! If you're doing water crossing and stuff out-of-warranty, you may want to invest in some dielectric grease to seal up those connectors....

Tech

might wanna clean out the electrical connectors for the t-case first. blow em out, no water/dirt

Tech

Did you ever have the steering column shell off? perhaps for an alarm install?

Tech

the other code is the heater for the same sensor. I'd check your MAF too...

Tech

Congrats on your success!

There is a pulley alignment procedure, and yes it's a terrible pain.....Especially the power steering!

Tech

Those trucks are known to be smelly after cold start. Keep in mind that the voltages for A/F sensors are not the same as O2. I've yet to replace an A/F sensor in a Pathfinder for anything other than physical damage. Feel better!

Tech

I remember installing those harnesses, but in Frontiers....not pathfinder for some reason....i'll investigate...it was a campaign...

Tech

why you replacing? I'd go from the wheel well. Take the front wheels off and go from the inner fender liner. You can bend it or remove it. The connectors also clip into little metal tabs. Unlock the grey tabs FIRST, or if the tab breaks, the connector wont stay secure. The sensor won't be hard to ge...

Search found 394 matches

Nissan Forums

Infiniti Forums

Datsun Forums

Technical Forums

Classifieds / Marketplace

Nissan Motorsports

General Forums