my trail limo

1pathfinder2crawl · Postby **1pathfinder2crawl** » Tue Jun 04, 2013 5:50 pm

http://i1306.photobucket.com/albums/s58 ... 695e77.jpg
sliders...
http://i1306.photobucket.com/albums/s58 ... 0bfd5d.jpg
http://i1306.photobucket.com/albums/s58 ... 8b26b4.jpg
only mods so far built my own sliders and skids
lift on the way and im building a spare tire carrier this weekend...

cgray · Postby **cgray** » Tue Jun 04, 2013 6:25 pm

What skid plates did you get?

1pathfinder2crawl · Postby **1pathfinder2crawl** » Tue Jun 04, 2013 6:35 pm

I made them. The gas tank One is titanium and all the others are 1/4 aluminum. Not sure about the titanium one yet but well see..

NmexMAX · Postby **NmexMAX** » Thu Jun 06, 2013 10:09 am

1pathfinder2crawl wrote:I made them. The gas tank One is titanium and all the others are 1/4 aluminum. Not sure about the titanium one yet but well see..

Any pics of the under armor?

cgray · Postby **cgray** » Thu Jun 06, 2013 9:18 pm

Pictures of them would be great. Even better would be a schematic with dimensions so I could make one for mine!

1pathfinder2crawl · Postby **1pathfinder2crawl** » Fri Jun 07, 2013 2:14 pm

I was going to install them tomorrow and if I do I'll take some pics along the way. I'll be using the factory mounting holes for the gas tank skid with some custom brackets I made. The transfer case and trans skids are two peaces and I will be welding small tabs to mount them with the rear diff skid I'll be welding some small tubing and tabs to mount it on and the oil pan skid will bolt on using stock locations but also covers the front diff. I will take some pics and give you the measurements. If everything works correctly I'll fab up a few sets of the brackets so some one with welding skills can mount there own..

my trail limo

my trail limo

Nissan Forums

Infiniti Forums

Datsun Forums

Technical Forums

Classifieds / Marketplace

Nissan Motorsports

General Forums