I have a 2006 S that came with the cutouts for fog lights, but no lights. Is it possible to punch out the cut outs, and install lights ? If so, has anyone ever done this?
Thanks.
Moderator: volvite
I think they're all pre-wired. What you'll have to do to make the job easier is jack up the front end and remove the tires. You'll need a philips screwdriver to pull back the inner fender. From there, you should see the wires.JP1548 wrote:I have a 2006 S that came with the cutouts for fog lights, but no lights. Is it possible to punch out the cut outs, and install lights ? If so, has anyone ever done this?
Thanks.
as cgray mentioned above, if you do not have the switch on/off on your signal indicator/headlight stalk by the steering, then it would not be plug and play. You would have to either wire seperately with it's own switch in the cabin, or tie it in to your low beams. Good luck with the upgrade.JP1548 wrote:Well, I have yet to begin this update. I did however pull back the wheel well liner and look inside. I can see where/how to remove the fog light hole plugs, but the wiring doesnt appear to be there. I believe someone on here somewhere said they were prewired. I have found the OEM fog lights online ranging from $85 - $200. At this point Im not quite sure what to do. I was hoping to just buy them, plug them in and go. Anyone know how complicated this wiring will be? Could I be getting in over my head?