So the Pathfinder has not seen many upgrades this winter so far.
that being said, I did upgrade my battery terminal clamps with some high quality terminal blocks from ruggedrocksoffroad.com
Link to them:
https://ruggedrocksoffroad.com/power-di ... rocks.html
here they are installed on the Pathfinder
These are very handy to have if you run a lot of aftermarket electronics on your Nissan. I run everything ranging from Lights to Air Compressors, to Subwoofers.
I did modify the negative battery cable so that it was compatible with the new terminal blocks. I used a dremel to cut off the clamp portion of the old cable and then bolted on the ground cable to the side of the terminal using the included hardware.
These terminal blocks use 13mm head accessory bolts and Allen head machine screws as clamp bolts.
You will also notice that there is a riser piece that raises up the fused link on the positive cable. You need this riser in order to properly install the terminal block on the positive side of the battery. Its a tight stretch but it does have enough slack to be positioned farther up without an issue.
Hood clearance is also not an issue. Our battery's sit lower in the engine bay than most people would think.