The Nissan Path

Litey

yeah cars get less mileage in winter , cause the air is less dense and harder to push through . Also like the above post the ethanol and less octane in winter gas . I just had the same thing I went from 18 avg to like 15/16 ... just changed my air filter , had 20k on it a bit too much , mileage got ...

Litey

Thanks Fluerys !!!

and spottyj here is the best link for a pathfinder brake job ...very complete ...

http://forums.nicoclub.com/how-to-repla ... 45492.html

Litey

If i only want to replace the pads only ....(not cut or change rotors) can I do that without removing the rotors or needing that tool . I have some cheap pads on there from previos owner that are so messy i want to put a nice ceramic or dust free pads on ...also could use a reccomendation on that ...

Litey

Thanks so much for a definitive answer . !!!
Now I will look around for that one on the driveshaft ...
and not think about getting rid of my grease gun

Litey

ARE there any zirk fittings or way to Lubricate the chassis ...???
or driveshaft ??
I do not see a thing underneath ...

Litey

Use this I heard it is easier than splicing wires ... Easy for you to do at home ... Hopkins Plug-In Simple 43565 T Connector Wiring Kit For Nissan Pathfinder '96-03; Altima, '96-01 / Infiniti QX4, '96-03 http://www.amazon.com/Hopkins-43565-Connector-Pathfinder-Infiniti/dp/B0002Q7ZU0/ref=au_pf_ss_6?...

Litey

How did you make that ? link to Thread ? or do you have instructions ?

Litey

THANKS Nighter ..

So do the Calipers just unbolt liek a GM or other with 2 long bolts
and then you just slip in the new pads ?

Litey

Unless... They mean lube the pivot points of the swingarms and A Arms with some spray lube ... all the joints that normally (usa made cars ) have grease fittings , were yeah.... sealed . I just sprayed some T-9 (my favorite ) (goes on wet , then hardens up to like a thin grease) on all the pivot poi...

Litey

Can't for the life of me figure this one out .
Bought a used 2004 , a month after notice the track bar or panhard bar
is bent toward the spare ... If the car was hit in the rear and the spare tire went into it it would be bent toward the axle ...
How could this bend have occured ?

Litey

I didn't see any zerk fittings under my 2004 ...
Are there any ways to lube the chassis ...if there are no grease fittings ?

Litey

o.k. thanks ...understand better now

Litey

this
http://www.thenissanpath.com/viewtopic. ... 66e82c11d2

and this recall
http://nissannews.com/newsrelease.do;js ... =1&id=1208

Litey

Don't these Cars have a 21 gal Tank ? If so , then 21 times 17 mpg
shhould give you 357 ...? why are you all saying so low ?

Litey

Sounds like some vacuum operrated switch is not getting enough vaccuum at idle to keep the flap or vwhatever open , add thottle,
adds vaccuum and then the heat flows in ...
He says he hears it leaking with engine off ....

Search found 17 matches

Gas mileage

Brake Pads

pads only

grease

Still Trying to get answer ...just to confiirm

Trailer Wiring

Access window

Pad s Calibers

Unless

Panhard Bar Bent

Lube points

mileage on a tank

your having the same issue as we all had see

Tank Size

Sounds like a vaccuum leak to me

Nissan Forums

Infiniti Forums

Datsun Forums

Technical Forums

Classifieds / Marketplace

Nissan Motorsports

General Forums