Lights I ordered https://www.amazon.com/dp/B07TN49HQR/ref=cm_sw_r_other_apa_i_.LCcEbACJMMW2 Ballasts I used https://www.amazon.com/dp/B07WSQ5RNZ/ref=cm_sw_r_other_apa_i_cNCcEbGQ374WY H1 HIDs https://www.amazon.com/dp/B0013CUA86/ref=cm_sw_r_other_apa_i_XNCcEbKWEW18E H3C HIDs https://www.amazon.com/dp...
I'll try to make this as brief as possible.... Had the factory headlights that loved to haze up no matter how many different kits I used to make them clear. I then installed HIDs into the same housings using a kensun bi-xenon 6000k kit off Amazon that served me well compared to factory lights for ab...
Driver side front turn signal socket busted a pin... Trying to find a replacement AutoZone and O'Reilly's don't have anything Came across these two part numbers and one says it will not fit and another says it will. So can anyone verify or point me to an easy fix ? 26243-9B909 And 26242-65Y00 This i...
Tried to find stuff on the forum about it and found the tsb however I am unable to find a site that explains how to fix it. Essentially my driver side window has a lot of play side to side (front of vehicle to the rear) Oddly enough my rear passenger window has the same issue. When the window is dow...
Last thing I need is the actual bracket to mount the 7pin connector to the hitch. I see two bolt holes but my kit did not come with the bracket. Anyone have the part number or know where I can get it? Thanks in advance!
If my 07 SE w/ 4x4 already has the plug under the dash to connect my brake controller to, do I need 24167-A6000 Wiring Harness - Vehicle Brakes to Trailer Brakes ?
[quote="Thupertrooper"][quote="TooTallMike"]I lifted my rear with Armada springs, gave me about 2.5" of lift. Needed the UCA bushings to adjust for camber.[/quote] Do you have a part number? I used the 4wd Tow package Armada springs. They were about .800†thick similar heig...
That would be tragic seeing as I installed the adjustable bushings in this and just got the alignment close. Might have to take it from the junk yard. It's just the sleeve got pushed up and grease came out and I want to pull the sleeve down and fill er up if possible.
Anyone know where I can get a replacement ball joint for my rear passenger side upper control arm? Seems like everywhere I looked it was only for the front.
I replaced mine and at first it seemed daunting and nearly impossible but once I got into it and got it done it's easily a weekend job if you take your time and nap occasionally. ðŸ‘