The Nissan Path

Aaron_kyboy

I checked voltage at the connectors and was seeing 12volts to the sensor. Going to get a better part. Thanks for the advice.

Aaron_kyboy

After reading my first post. I wasn't very clear. I dropped the hub with wheelsensor connected, wire broke and new sensor ohm 550 Kohms which was different than the original of 115kohm reading. I still installed anyway hoping it would be fine because it's better than open reading. This is what origi...

Aaron_kyboy

So more than likely my ABS system still sees a malfunction it won't clear at this point? I did have a heck of a time getting the quick disconnect off and the plastic connected goes together but doesn't really lock anymore due to the force I used to get it out. Is this a possible issue as well?

Aaron_kyboy

To quickly bring everyone up to speed. I have a 2007 2wd Pathfinder and I recently replace upper and lower ball joints. Unfortunately I dropped the driver side hub and steering knuckle. About 60lbs of force and after an Ohm check of the sensor showed open I bought an Autex ABS sensor off of Amazon. ...

Aaron_kyboy

I just wanted to chime in. I agree with the previous post. I accidentally used Dot 3 brake fluid instead of Dot 4 on my last change and after completely draining and rebleeding with Dot 4 a huge difference. Before the rebleed I had ABS kicking in for the smallest crap. Not saying you did the same bu...

Search found 5 matches

Wheel sensor Reset

Chiming in new to the Forum

Nissan Forums

Infiniti Forums

Datsun Forums

Technical Forums

Classifieds / Marketplace

Nissan Motorsports

General Forums