Search found 39 matches
- Thu Mar 02, 2023 8:41 pm
- Forum: NAV/GPS/Audio/Electronics
- Topic: 2-3OHM speakers
- Replies: 2
- Views: 6548
Re: 2-3OHM speakers
Curious if you ever found some.
- Sat Nov 19, 2022 6:31 pm
- Forum: General Automotive
- Topic: Filter Comparison
- Replies: 2
- Views: 2361
Re: Filter Comparison
Mobile 1 
in mine.
in mine.- Fri Nov 18, 2022 11:26 am
- Forum: R51 Engine, Driveline and Powertrain
- Topic: Autozone carries OEM Nissan Parts?
- Replies: 1
- Views: 484
Autozone carries OEM Nissan Parts?
Finally got a small evap leak fixed, it was the purge valve. Not a tough fix. But since I did load up the parts cannon, gas cap, vent valve, and purge valve, I figured I would replace the vent valve since I already bought it. It was the one part my dealer didn't have so I rolled the dice and got it ...
- Tue Sep 20, 2022 2:34 pm
- Forum: R51 Engine, Driveline and Powertrain
- Topic: Rounded manifold nut 2008 V8
- Replies: 9
- Views: 1054
Re: Rounded manifold nut 2008 V8
With enough Free All/PB Blaster these bolt extractors from HF haven't let me down yet.
https://www.harborfreight.com/38-in-dri ... 67894.html
https://www.harborfreight.com/38-in-dri ... 67894.html
- Fri Sep 09, 2022 11:01 am
- Forum: R51 Engine, Driveline and Powertrain
- Topic: Mechanical fan clutch always roaring
- Replies: 8
- Views: 1058
Re: Mechanical fan clutch always roaring
Used to call that, shaking hands with death 
- Fri Sep 09, 2022 7:35 am
- Forum: R51 Suspension and Steering
- Topic: Got rust?
- Replies: 8
- Views: 3003
Re: Got rust?
I roll the 18V 1/2" Milwaukee 2767 for the big stuff. It's either going to remove it or snap it.
- Fri Sep 09, 2022 6:07 am
- Forum: R51 Suspension and Steering
- Topic: Lower front strut bolt
- Replies: 6
- Views: 2664
Re: Lower front strut bolt
Isn't suspension hardware grade 10.9?
- Tue Sep 06, 2022 6:44 pm
- Forum: R51 Suspension and Steering
- Topic: Lower front strut bolt
- Replies: 6
- Views: 2664
Re: Lower front strut bolt
While I'm unsure of the length I believe the original bolt was a M14x1.5 flanged bolt/nut combo.
- Sat Aug 20, 2022 12:19 pm
- Forum: R51 Engine, Driveline and Powertrain
- Topic: Rear wheel bearings.... done.
- Replies: 1
- Views: 550
Rear wheel bearings.... done.
Cross rear wheel bearings of the list. Could not have done it without Smj's how to guide.
- Sat Aug 13, 2022 7:36 am
- Forum: R51 Suspension and Steering
- Topic: Got rust?
- Replies: 8
- Views: 3003
Got rust?
- Fri Jul 22, 2022 6:35 am
- Forum: R51 Engine, Driveline and Powertrain
- Topic: 06 Pathfinder LE ATF fluid type
- Replies: 2
- Views: 624
Re: 06 Pathfinder LE ATF fluid type
I run the Valvoline MaxLife Multi-Vehicle Automatic Full Synthetic Transmission Fluid in both the transmission and transfer case, no problems with either.
- Fri Jul 15, 2022 8:03 am
- Forum: R51 Body Interior and Exterior
- Topic: 2009 PF V6 SE spec auto dim rear view mirror?
- Replies: 7
- Views: 2698
Re: 2009 PF V6 SE spec auto dim rear view mirror?
I guess that's is indeed a basic rear view mirror then? Is it easy to retrofit one perhaps. ? Virtually all Nissan Homelink mirrors only require power and ground to work. Some of them have other functionalities like outside temperature, but they'll all dim normally and work the garage door even if ...
- Sat Jul 09, 2022 6:31 pm
- Forum: R51 Engine, Driveline and Powertrain
- Topic: Oil leak location.
- Replies: 5
- Views: 701
Re: Oil leak location.
I had a leaking driver's side cam position sensor that looked similar to that.
- Fri Jul 08, 2022 6:30 pm
- Forum: R51 Body Interior and Exterior
- Topic: Dash mat recommendation for 2009 SE
- Replies: 3
- Views: 2523
Re: Dash mat recommendation for 2009 SE
Check out RA, under the interior section.
- Wed Jul 06, 2022 8:21 am
- Forum: R51 Suspension and Steering
- Topic: Ride height stock suspension
- Replies: 12
- Views: 3782
Re: Ride height stock suspension
The rear springs should set the ride height, not the shocks. I went with the Moog 81119 rear springs to keep the stock(ish) ride height.
Find Your Forum!