The Nissan Path

coferj

asnorton44 wrote:You can refer to this thread:

http://npora.ipbhost.com/index.php?showtopic=11442

Thanks!

coferj

asnorton44 wrote:I would check for any vacuum leaks, clean out EGR ports in intake, and check your carbon canister.

Ok, I think I can find the egr, but where is the canister you speak of?

coferj

Ok, pulled codes. P0443 and P0138. Had these codes before I replaced the MAF, and problems didn't start until last time I had the parts house clear the codes out. I didn't think a bad bank 1 sensor 2 could necessarily effect the engine performance as it is reading the output of the cat?

coferj

I haven't been able to get by a shop to get the codes pulled. All of this started when I swung by, had them pull codes for my SES and reset. The original codes were 0443 and...I can't remember the second one, but it's the one that points to the bank 1 rear O2 sensor.

coferj

105K, having an issue that just started up with the idle on the vehicle. Started with the engine idling fine, but lagged in the 1500 rpm range, then perked up, and then would hit cutoff at appr 2350 rpm, due to the "safe mode" or whatever. I had just replaced the MAF with the maxima versio...

coferj

Figured I would post an update. Not long after the problem started, based on someone else's advice, he sprayed starter fluid into the intake tube. Although I may have had aprehension about this method, he has said that the problem was resolved and has not returned since.

coferj

Rogue9 wrote:can't go wrong with brembo's.

Ahh, didn't think about them. Thanks!

coferj

Yes, I searched. I need to replace the pads/rotors on my pathy, wondered what, if any, suggestions you all may have on the combo? I don't need anything specialized, as my commute is pretty lax and I really only drive to work and home. I'm seeing alot of Akebono mentioned for pads, but nothing really...

coferj

same thing.. NISSAN PATHFINDER 2WD & 4WD: Go To Matching Vehicles Make Model Year Bolt Pattern OEM Wheel Size Stud Size Hub enter Bore Offset NISSAN PATHFINDER 2WD & 4WD 1987-04 6 X 139.7 6 X 5.5 12 X 1.25 100.0 Thanks!

coferj

Friend of mine is selling his rims and tires from his 2003 4wd, and he stated upon learning my interest that the lug patterns were the same. Can anyone verify or deny this? I tried searching here and web but can't find anything really difinitive?

coferj

Same here, just thought it was a bad connection on the batt terminal because it's so intermittent.

coferj

ok, posting up in regards to a problem my buddy is having, just started tonight. when he cranks up, engine will start up and then rpm's drop and engine stalls out. it will do it every time, but if you give it a little gas when starting the rpm will drop just a bit on the downside and then adjust pro...

coferj

Just took a 1000 mile round trip road burn last weekend...before my MAF started crapping out, I was getting about 300 on tank. Haven't had a chance to check it again since I replaced the sensor.

Search found 13 matches

Intermitten rough idle - Where do I go from here?

Opinions on basic pad/rotor combos

2wd vs 4wd Bolt Pattern

2003 engine stalling after cranking, 85k

Nissan Forums

Infiniti Forums

Datsun Forums

Technical Forums

Classifieds / Marketplace

Nissan Motorsports

General Forums