lol i mean the line running underneath your vehicle not the tranny fluid dipstick. but yes it is bolted down by a 10mm. make sure you get the correct barbed connectors I used 5/16 i belive but i undid mine because it's covered under warranty for me. I heard the barbed connectors were 3/8. ? I am go...
Panda...on the 06, it is on the passenger side..locked down with a 10mm bolt....guess I should have looked earlier...again, my fluid seemed to look ok and my coolant is greenish like new coolant...
Just checked the tran fluid in my Pathfinder...bought it brand new in 2006 and didnt know you could check the tran fluid ( dealer said the trans was a sealed unit )...anyway...fluid is red in color.clean looking and.doesnt smell burnt or funny...saw the hoses for the radiator and bypass looks simple...
Hey Guys...hate to be a pain on this, but I want to be sure if I do this mod, I do it right. Looks like we are doing it 2 ways here: 1. Simply splicing the 2 bottom hoses on the radiator with a barbed fitting and plugging the rad with 5/16" vacuum caps. 2. removing the end of the long hose ( dr...
I am out of my warranty..85k miles...im going to do the by pass this weekend. Not sure if I will put on another external cooler or not. I dont tow anything and the Path is driven around town mostly.
I have been reading this post for an hour now..I have a 06' Pathfinder and I am worried that coolant will leak into the internal trans cooler and jack my transmission. Not being a mechanic...here is where I am at...there is an internal trans cooler and an external cooler correct? does the external t...
I bought my 2006 Pathfinder new from our local dealer. About 3 months after I bought it, a deer ran into the front right quarter panel of the car. Took it to the dealer for the repairs except for the plastic lining in the fender well, which they fixed and lined up. After a few weeks, I noticed there...
Given my ineptness of vehicle interworkings, I thought I'd post on this site. For the last couple of months my '05 Pathfinder has been slow to start. It's not a battery issue, as I recently had this replaced. The truck turns over fine, but some mornings (this usually happens in the morning after tr...
not quite the diy i was lookin for but thx :shock: Sorry..I am not a mechanic...but you have to remove the air plenum in the center..2 clams on each tube and 2 screws...set it off to the right. I used a 3/8" ratchet socket wrench in the belt tensioner, pushed it left and then just tied off my ...
should do a DIY for the '06 on our belts. i def need one before attempting ;) *hint* *hint* Ok...replaced the serpentine belt this morning...not too hard, not that easy..lol...I didnt use a 14mm socket to releaset the tension, I used a 3/8" ratchet drive and a breaker bar and pushed it left. A...