Search found 136 matches

Return to Search

by asgard
Thu Jan 05, 2012 1:51 pm
Forum: 2005-2012 Pathfinder (R51)
Topic: Scangauge 2 or Bully Dog GT
Replies: 2
Views: 3296

Scangauge 2 or Bully Dog GT

I have recently been getting a check engine light and while I would like to check this out and clear it i would also like some additional information. I am looking for advice by way of actual user reviews as to which one is best and why. appreciate there is a reasonable cost difference but I am open...
by asgard
Mon Jan 02, 2012 4:22 pm
Forum: R51 Engine, Driveline and Powertrain
Topic: U-joints
Replies: 25
Views: 19776

From what I see in the picture the unit is just a glorified G clamp. I would thing a set of sockets and a G clamp it's done no hitting required. I have a slight drive vibration through the gas pedal, is this the start of U joint failure. By checking lateral movement do you mean in and out play or up...
by asgard
Fri Dec 09, 2011 1:52 pm
Forum: R51 Engine, Driveline and Powertrain
Topic: Timing Chain Show claim DENIED
Replies: 6
Views: 5639

I agree with your statement. If they are unwilling to consider a claim, even good will I fully understand your sentiment on leaving the brand. I would have thought that a non service part like a timing chain should be expected to last the duration of the engine - whatever that norm is determined as....
by asgard
Tue Nov 29, 2011 6:52 pm
Forum: R51 Electrical
Topic: 4pin to 7 pin conversion
Replies: 9
Views: 16661

4pin to 7 pin conversion

I have a 2007 LE with the 4 wire connection mounted beside the hitch receiver. I am looking to put on a 7 pin.

Is there a kit from Nissan.? also is the wiring loom already there for connection and where can you find it?

Thanks
by asgard
Tue Nov 29, 2011 4:09 pm
Forum: NAV/GPS/Audio/Electronics
Topic: 4 wire to 7 wire conversion
Replies: 0
Views: 3108

4 wire to 7 wire conversion

I have a 2007 LE with the 4 wire connection mounted beside the hitch receiver. I am looking to put on a 7 pin.

Is there a kit from Nissan.? also is the wiring loom already there for connection and where can you find it?

Thanks
by asgard
Tue Nov 22, 2011 3:09 pm
Forum: 2005-2012 Pathfinder (R51)
Topic: Bleeding brake system
Replies: 10
Views: 7257

I have always used a pressure reserve when doing the brakes. It gives you a steady pressure - no pumping of the pedal and chance of air in the system. I have always done the furthest first as previously detailed, as this is DOT 3 fluid - which is hygroscopic , the used fluid should be safely dispose...
by asgard
Mon Oct 24, 2011 10:01 am
Forum: 2005-2012 Pathfinder (R51)
Topic: HID for 2008
Replies: 22
Views: 14310

I am thinking of the HID kit for my 2007. I looked the ddm site and wondered if someone could itemize the order, I looked at the hi/lo 35 watt slim ballast system 5000k do you need the HID wiring harness and the error code eliminator? they are also showing a 55 watt lamp - has anyone tried these? I ...
by asgard
Wed Sep 28, 2011 11:49 am
Forum: R51 Body Interior and Exterior
Topic: PIAA 510 ATP Light Install
Replies: 25
Views: 28468

I would think this would be very straight forward. If you use a relay with the feed from the battery then you take a feed line from the head light high beam wire and use it th switch the relay. In line fuse on power in from battery, connection to earth, connection to lights connection to switch high...
by asgard
Tue Sep 20, 2011 3:30 pm
Forum: 2005-2012 Pathfinder (R51)
Topic: what do you thing about these lights
Replies: 13
Views: 9272

I thought that - too big - lasted 15 minutes - just enough time to take the picture.

Is this a HID light bar? I have seen them listed - very expensive. Were there no women in the woods that day to garnish your picture. I was getting used to them.
by asgard
Thu Sep 15, 2011 8:48 am
Forum: 2005-2012 Pathfinder (R51)
Topic: A/C Question
Replies: 10
Views: 6153

With regards to the pressure test gauge . I bought one of the refill kits - I thing from Walmart and it had a gauge in the kit - simple to connect and read, then fill as required.
by asgard
Wed Sep 14, 2011 9:15 am
Forum: 2005-2012 Pathfinder (R51)
Topic: what do you thing about these lights
Replies: 13
Views: 9272

That is what I thought after I mounted them - hence they only lasted about 15 minutes and were never wired in. The mounting on the bar takes 5inch or there about - these were 7 inch lights. I will look for a set of 5 inch lamps that don't break the budget. Just looking for more long range lighting. ...
by asgard
Tue Sep 13, 2011 3:54 pm
Forum: 2005-2012 Pathfinder (R51)
Topic: what do you thing about these lights
Replies: 13
Views: 9272

Thanks for the training I sure needed it.


hope this works. Picture is a little misty and as I took them off it is all I have
Image
by asgard
Tue Sep 13, 2011 1:18 pm
Forum: 2005-2012 Pathfinder (R51)
Topic: what do you thing about these lights
Replies: 13
Views: 9272

I am going to try adding the photo again.

Image
by asgard
Tue Sep 13, 2011 9:45 am
Forum: 2005-2012 Pathfinder (R51)
Topic: what do you thing about these lights
Replies: 13
Views: 9272

what do you thing about these lights

https://lh4.googleusercontent.com/-mwaI94a5UJE/Tm-GTvdCf6I/AAAAAAAAABc/taUb3rQ0qzs/CIMG3284.JPG I made this up using 2 7 inch long distance driving lights mounted on custom mounts through the grill openings, they were to have stabilizers on the top back onto the top of the grill, I wired a harness ...
by asgard
Mon Sep 12, 2011 10:28 am
Forum: 2005-2012 Pathfinder (R51)
Topic: First Tank -10.8 MPG REALLY?
Replies: 28
Views: 19702

I agree with you that is way too low for comfort. taking your experience into account you will probably already thought of giving the fuel system a clean out using Seafoam or equivalent. It might be that it is a little waxed up at 32000. It is cheap and easy to do and if it remains the same it might...

Go to advanced search