Bad vibration

The Gas and Diesel Engines - VQ40De, VK56DE, YD25DDTi, V9X, Transmission, Transfer Case, Oil, Differentials, Axles, Exhaust...

Moderator: volvite

chrisloftis
Posts: 5
Joined: Tue May 27, 2014 4:14 am
Location: Moultrie Ga

Bad vibration

Postby chrisloftis » Tue May 27, 2014 4:19 am

When accelerating I get a bad vibration between 40-60 mph and also when under a load. It is on a 08 pathfinder with the v6. I have changed the spark plugs but that hasn't fixed the problem. Are there any suggestions?


User avatar
eieio
Sponsored Member
Posts: 1841
Joined: Fri Jul 17, 2009 6:42 am
Location: Prescott, Az.

Re: Bad vibration

Postby eieio » Tue May 27, 2014 6:17 am

chrisloftis wrote:When accelerating I get a bad vibration between 40-60 mph and also when under a load. It is on a 08 pathfinder with the v6. I have changed the spark plugs but that hasn't fixed the problem. Are there any suggestions?
check your u-joints

jman9895
Posts: 89
Joined: Fri Mar 21, 2014 5:53 am
Location: MA/NH Border

Postby jman9895 » Tue May 27, 2014 7:26 am

^what he said

chrisloftis
Posts: 5
Joined: Tue May 27, 2014 4:14 am
Location: Moultrie Ga

Postby chrisloftis » Tue May 27, 2014 2:47 pm

Just was sure it was the motor. If I let off the gas and coast it quits but starts again when I hit the gas

User avatar
eieio
Sponsored Member
Posts: 1841
Joined: Fri Jul 17, 2009 6:42 am
Location: Prescott, Az.

Postby eieio » Tue May 27, 2014 5:21 pm

chrisloftis wrote:Just was sure it was the motor. If I let off the gas and coast it quits but starts again when I hit the gas
check your u-joints

skinny2
Sponsored Member
Posts: 1531
Joined: Sat Dec 26, 2009 10:07 pm
Location: BFE, Ohio

Postby skinny2 » Tue May 27, 2014 6:24 pm

eieio wrote:
chrisloftis wrote:Just was sure it was the motor. If I let off the gas and coast it quits but starts again when I hit the gas
check your u-joints
I can't hear you over the bad vibration from my u-joints...what'd you say?? :lol:

User avatar
eieio
Sponsored Member
Posts: 1841
Joined: Fri Jul 17, 2009 6:42 am
Location: Prescott, Az.

Postby eieio » Tue May 27, 2014 7:16 pm

skinny2 wrote:
eieio wrote:
chrisloftis wrote:Just was sure it was the motor. If I let off the gas and coast it quits but starts again when I hit the gas
check your u-joints
I can't hear you over the bad vibration from my u-joints...what'd you say?? :lol:
:lol:

chrisloftis
Posts: 5
Joined: Tue May 27, 2014 4:14 am
Location: Moultrie Ga

Postby chrisloftis » Wed May 28, 2014 3:34 am

Sounds good I'll check them this afternoon and look to replace them. Thanks for the help guys. Looking forward to talking with yall on the forum

chrisloftis
Posts: 5
Joined: Tue May 27, 2014 4:14 am
Location: Moultrie Ga

Postby chrisloftis » Tue Jun 03, 2014 11:30 am

Going to install u-joints. Would it have a steel yoke or a aluminum yoke? 08 SE Pathfinder 2WD

User avatar
lebanesepathy
Posts: 76
Joined: Thu May 29, 2014 10:16 am
Location: lebanon

Postby lebanesepathy » Tue Jun 03, 2014 12:37 pm

Make sure your front wheels are balanced. They kinda cause shaking around 60mph(100km/hr) if they are not.

User avatar
RCAPathfinder
Posts: 293
Joined: Fri Apr 05, 2013 12:30 pm
Location: CENTRAL NJ

Postby RCAPathfinder » Sun Jun 08, 2014 4:46 pm

I have been having the same problem. I replace the rear driveshaft front u joint and it didnt go away. I will replace the rear u joint this week....

User avatar
ShipFixer
Posts: 777
Joined: Sun May 24, 2009 9:52 am
Location: San Diego, CA

Postby ShipFixer » Tue Jun 10, 2014 2:59 pm

It's usually one of the front ones (it spins in 2WD too). I went for extra credit and had a bent front driveshaft at the same time.


Return to “R51 Engine, Driveline and Powertrain”