The Nissan Path

Just bought my first Pathfinder. 2006 LE model



It replaces my 2000 Subaru Outback Wagon.

I love it but I do find the ride somewhat 'floaty' on bumpy roads. Is this normal or just a need for tighter suspension mods etc?

Congrats and welocome.

Get the AirLift 1000. It will stiffen up the rear and prevent some of the bounciness. Also make sure to see if the Radiator/Transmission bypass was done. If you are under 80000 miles you might still be ok. Read some of the treads writen here for more info.

Greetings~~

hfrez wrote:Congrats and welocome.

Get the AirLift 1000. It will stiffen up the rear and prevent some of the bounciness. Also make sure to see if the Radiator/Transmission bypass was done. If you are under 80000 miles you might still be ok. Read some of the treads writen here for more info.

Not sure I want an 'airlift' system. I have reservations about air bag type systems. I think I'd rather have a regular type shock instead on all four corners.

Yes, I've read some of the threads about the radiator/transmission bypass. Is there a complete instructional thread or document with pics and step by step instructions that I can download? I've learned over the years that I am somewhat mechanically challenged and I will require all the help I can get.

Thanks much.

The Airlift 1000 is a great upgrade. It's a super durable airbag that fits inside the factory coil spring. They aren't a spring replacement. Tons of drivers use them on this forum. In most folks opinion, the Pathfinder has an under-sprung rear-end. The airbags really help balance out the ride and you can tailor the pressure to suit your needs (daily use, towing, road-tripping...). I use them. They're super nice.

welcome.

Well, I decided to purchase an AirLift system after all and now am waiting for it to arrive to install it.

Why? Well, I bought this.....



As a result, I also just installed the 7pin trailer wiring connector and relay under the hood. I am waiting for the electronic brake controller to come in and have also bought the wiring harness for that (where is the connection located anyway?)

Any suggestions for a weight distribution hitch set up? The toy hauler weighs 4200lbs empty.

Thanks much.

Nice purchase. The 7 pin connector should connect under the rear end on the driver side. You will see the plug where the 4 pin should already be installed.

the Weight distribution hitch would be recommended. the airlift is not an alernative to thw WDH. You will have more control over the trailer with a WDH.