Page 1 of 1
How to run power wire through firewall ?????
Posted: Sun Oct 24, 2010 11:03 am
by 1997pathfinderSE
Hello everybody I need help finding a way to run the power wire from the battery to the cargo area in a 97SE if possible through the passenger side and without drilling a hole but any suggestions will help thank you in advance and god bless.
Posted: Sun Oct 24, 2010 10:04 pm
by xd9-g19
You can try to run it through where the stock harness goes through, if not there is normally a hole already pre drilled but has a rubber gromet around it.
You can try to run it through where the stock harness goes t
Posted: Mon Oct 25, 2010 8:36 pm
by 1997pathfinderSE
Yeah after a few hours of looking i think i finally found a place on the passenger side that goes through looks small but itll work thanks for the advice i really didnt want to drill a hole and now dont have to.
Posted: Tue Oct 26, 2010 6:16 pm
by Kami
I didnt want to use the firewall route and draw wies through there, so i just fed the wires through the driver side door pannel from inside the hood..not as clean but easier and dont worry about shit potientaly gettign through the rubber near the gas/break pedal.
Ill post a pic tomorrow so u can see how mine is.