Page 1 of 1
Magnaflow Stainless Cat-back
Posted: Sat Nov 15, 2008 8:40 am
by GimmieSumMo72
I'm new to the forums, and searched for what kind of exhausts people put on their Pathfinders and the most common that came up was the Gibson set up which really didn't get good reviews.
I was wondering if anyone has used the Magnaflow Cat-back set up?
http://www.magnaflow.com/02product/shop ... ll&id=4313
The one linked above is set up for a Frontier, but I'm guessing the Frontier and the Pathfinder has the same chassis.
Would this fit on the Pathfinder Off-Road?
Any suggestions before I click the check-out button?
Re: Magnaflow Stainless Cat-back
Posted: Sat Nov 15, 2008 6:13 pm
by Npath
I doubt it'll fit on a Pathfinder as I don't see Pathfinder accessories on the website.
Re: Magnaflow Stainless Cat-back
Posted: Sat Nov 15, 2008 10:50 pm
by V8supercarsrock
[quote="GimmieSumMo72"
The one linked above is set up for a Frontier, but I'm guessing the Frontier and the Pathfinder has the same chassis.
Would this fit on the Pathfinder Off-Road?
Any suggestions before I click the check-out button?[/quote]
As far as I am aware the Frontier (same as D40 Navara in Aust ) is about 300mm longer in the chassis between the axles but I could be incorrect .....
Cheers
David
Re: Magnaflow Stainless Cat-back
Posted: Sun Nov 16, 2008 7:09 am
by GimmieSumMo72
Npath wrote:I doubt it'll fit on a Pathfinder as I don't see Pathfinder accessories on the website.
yeah i checked that too...
but aren't the chassis on both similar? shouldn't it be somewhat compatible?
the only problem i see is length of the tail pipe.
V8... is 300mm close to 12 inches (1 foot)?
Re: Magnaflow Stainless Cat-back
Posted: Sun Nov 16, 2008 4:35 pm
by SilverGhost
GimmieSumMo72 wrote:... is 300mm close to 12 inches (1 foot)?
Damn close . . . 300mm=11.81 inches.
Posted: Sun Nov 16, 2008 6:58 pm
by GimmieSumMo72
im kinda stuck on this cat-back because its easy to install and love the sound!
borla has a muffler but that entails welding and use of the stock piping which is like 2 inches instead of 3 inches.
wouldn't that still restrict the outflow?
Posted: Wed Nov 19, 2008 2:43 pm
by bender031
everything forward of the muffler should fit, however the pipe after the muffler would all most-likely need modified, the frontier is solid axle, the independent rear on the pathy leaves MINIMAL room for the tailpipe to go through. i'd highly doubt the tail section of the kit will be usable at all.
let us know how it goes (and sounds)
Posted: Thu Nov 20, 2008 10:52 am
by GimmieSumMo72
thanks!!!
i guess i'll wait around and look for other ones!