Thermostat and coolant change
Posted: Thu Feb 20, 2020 1:23 pm
Hey all,
So its been at least 6 years since my last thermostat change, and about 3 years on the coolant. I've noticed that my thermostat may be sticking a bit when under heavy load, and we are planning a big trip in April, so thought it'd be good to change out the thermostat.
Bought a Nissan OEM part from CourtesyNissan for $21.71, and added the $1.71 for the new gasket. Total was $29.48 shipped to my parcel service in Pembina.
Started by draining the rad. Popped the cap on both the rad and the resevoir tank and undid the draincock on the bottom of the rad. Took about 20 minutes.
Once the water level was below the thermostat, I started to work on the 3 bolts for the thermostat. Managed to get them all out, though I did drop one, so I had to drop the skid plate to find it.
One thing I noticed was that there was no gasket on my old thermostat. I'm the one that changed it out about 6-7 years ago. Did I not put a gasket in? (rhetorical question...) In all these years, it has never leaked, so I guess we dodged a bullet. Checked to see if the old gasket fell down or was stuck to the block. Nothing. and the mating surface was clean as a whistle.
Put in the new gasket, threaded the bolts back in, and torqued to 8 ftlbs (90 in-lbs or so), and refilled the rad. Its taken about 2 days to get the air bubbles to burp out, but seems to be running like a top!
The old coolant actually didn't even look that bad. I replaced with an aftermarket product which is still blue, and shows it is for Nissan/infinitis.
Next up, have to change out the power steering pressure line. Got a leak! Also a rack and pinion boot. Then we should be good to go for our trip!
t
So its been at least 6 years since my last thermostat change, and about 3 years on the coolant. I've noticed that my thermostat may be sticking a bit when under heavy load, and we are planning a big trip in April, so thought it'd be good to change out the thermostat.
Bought a Nissan OEM part from CourtesyNissan for $21.71, and added the $1.71 for the new gasket. Total was $29.48 shipped to my parcel service in Pembina.
Started by draining the rad. Popped the cap on both the rad and the resevoir tank and undid the draincock on the bottom of the rad. Took about 20 minutes.
Once the water level was below the thermostat, I started to work on the 3 bolts for the thermostat. Managed to get them all out, though I did drop one, so I had to drop the skid plate to find it.
One thing I noticed was that there was no gasket on my old thermostat. I'm the one that changed it out about 6-7 years ago. Did I not put a gasket in? (rhetorical question...) In all these years, it has never leaked, so I guess we dodged a bullet. Checked to see if the old gasket fell down or was stuck to the block. Nothing. and the mating surface was clean as a whistle.
Put in the new gasket, threaded the bolts back in, and torqued to 8 ftlbs (90 in-lbs or so), and refilled the rad. Its taken about 2 days to get the air bubbles to burp out, but seems to be running like a top!
The old coolant actually didn't even look that bad. I replaced with an aftermarket product which is still blue, and shows it is for Nissan/infinitis.
Next up, have to change out the power steering pressure line. Got a leak! Also a rack and pinion boot. Then we should be good to go for our trip!
t