Page 1 of 1

2006 Nissan pathfinder Cranks But doesn't start when hot

Posted: Thu Apr 09, 2020 4:58 pm
by veroonc
I drive the pathfinder for 30 mins, turn off and try to restart doesn't start.
Cold starts- Perfect
Parts Replaced
-Spark plugs
-Coil packs
-Injectors
-Fuel Dampers
-Fuel Pump
-Both Camshafts position Sensor
-Crankshaft Position Sensor
-Ipdm Unit With New Relays & Fuses
The Pathfinder is showing no codes, only tpms light.
It seems as if there is no spark when hot.
Any Advice is helpful

Posted: Fri Apr 10, 2020 10:10 am
by smj999smj
Did you use OEM crank and cam pos sensors?

Posted: Sun Apr 12, 2020 10:35 pm
by veroonc
OEM Crankshaft sensor and Cam Shaft

Posted: Mon Apr 13, 2020 2:08 am
by smj999smj
Pull out a coil pack, install a spark plug in it and ground it while someone tries to start the vehicle to confirm no spark. If you have spark, check fuel pressure. If you don't have spark, you'll have to refer to the factory service manual's engine control section for the diagnostic steps for no start/no spark conditions. NICO Club has free Nissan FSM's at their site.