Page 1 of 1

Replaced ABS Module

Posted: Fri Mar 06, 2020 1:54 pm
by PathfinderDaddy
Had an issue where (Slip, VSC, ABS and 4X4) lights would come on

Changed the rear Speed sensor as LH Rear was not showing

then replaced the Wire as LH Rear was not showing

Replaced the ABS and now all is well except

I have no display and the 4x4 light is on I can still engage 4x4 but the light is annoying, Wondering if anyone has the diagram of the wiring for the switch or any other Ideas Nissan say 5 hours just to diagnose

Posted: Fri Mar 06, 2020 2:57 pm
by dukeofdirt
I am on my third ABS module at 179K Is there a more permanent fix? Are all those lights really anything to worry about? I have no stopping issues

Posted: Sun Mar 08, 2020 5:08 am
by smj999smj
Factory service manual has wiring diagrams:

https://www.nicoclub.com/nissan-service-manuals

Posted: Sun Mar 08, 2020 8:29 am
by eieio
[quote="smj999smj"]

You're back!
Hope all went well!
Eric
:)

Posted: Sun Mar 08, 2020 3:40 pm
by PathfinderDaddy
smj999smj wrote:Factory service manual has wiring diagrams:

https://www.nicoclub.com/nissan-service-manuals
Thank You

Posted: Sun Mar 08, 2020 3:44 pm
by PathfinderDaddy
dukeofdirt wrote:I am on my third ABS module at 179K Is there a more permanent fix? Are all those lights really anything to worry about? I have no stopping issues
im starting to think its the plug to the rear speed sensor going to make a jumper tomorrow and test, I say that because the wire is replaces the sensor is new and so is the ABS module could be the plug to the module as well

Posted: Sun Mar 08, 2020 6:10 pm
by smj999smj
eieio wrote:
smj999smj wrote:
You're back!
Hope all went well!
Eric
:)
I can only type with left hand, so not really back 100%. Doc found more damage than had expected. I check in to delete some spam here and there.