Plasti Dip finished project
Posted: Sun Dec 13, 2015 2:27 pm
This stuff is great to work with
The Nissan Path
The World Wide Nissan Pathfinder Owner's Forum | NICOclub.com
https://www.thenissanpath.com/
Plasti Dip finished project
Page 1 of 1
Posted: Mon Dec 14, 2015 11:43 am
Nice job! I ended up taking it off the back and badges again. Just didn't work as well on the silver of the car. The grille is a big improvement, though!
Posted: Mon Dec 14, 2015 2:42 pm
Well it looked good then.. got a radiator swap today, and the tech nicked the dip on the grill, a piece is peeling off..... can I just throw another coat over it or start from scratch. You can tell where he was leaning up against it too, kinda pissed!
Posted: Wed Dec 16, 2015 12:51 pm
Looks good! 
I did my back end last summer and it's holding better than the truck bed liner I put over the plastic chrome side molding . I even roughed up the surface before I started! That's a slippery surface for sure!! lol
I did my back end last summer and it's holding better than the truck bed liner I put over the plastic chrome side molding . I even roughed up the surface before I started! That's a slippery surface for sure!! lol
Posted: Wed Dec 16, 2015 1:25 pm
Touch up to some degree is possible. But if it has a rolled edge you'll need to peel it off.
Posted: Mon Dec 21, 2015 7:25 pm
Looks great, I did the same on the back of my wifes pathfinder, love it in black. I also did her rims and they came out great too... trying to convince her on the grill