How to Paint and Color Fill Emblems - Ghost Style
Posted: Fri Jun 30, 2017 2:45 am
The front emblem was done the same way. I just took more detailed pictures of the rear emblem.
I scuffed the surface with ScotchBite brown pad, then painted the whole thing satin black. The last coat was laid on thick. The wet paint fades to satin after drying for a day. Since the emblem got a final coat of satin clear, the black could have been gloss or flat, but I happened to have satin on hand.
After the black paint has dried thoroughly, mask off the area around the letters
Spray with gray
Before the gray dries, remove the tape, put mineral spirits on a paper towel, and rub the emblem on it face down to remove the gray from the face
After the gray had dried. Notice that the finish of the black paint has been dulled from rubbing it on the paper towel. clear-coating will make everything uniform. This is also an opportunity to sand out any dust nibs, like the one on the lower left.
I scuffed the surface with ScotchBite brown pad, then painted the whole thing satin black. The last coat was laid on thick. The wet paint fades to satin after drying for a day. Since the emblem got a final coat of satin clear, the black could have been gloss or flat, but I happened to have satin on hand.
After the black paint has dried thoroughly, mask off the area around the letters
Spray with gray
Before the gray dries, remove the tape, put mineral spirits on a paper towel, and rub the emblem on it face down to remove the gray from the face
After the gray had dried. Notice that the finish of the black paint has been dulled from rubbing it on the paper towel. clear-coating will make everything uniform. This is also an opportunity to sand out any dust nibs, like the one on the lower left.
