Page 1 of 1
Running Board Bolt Size
Posted: Tue Oct 22, 2019 3:16 pm
by Paramedic835
Hello Pathfinder gurus,
Can anyone tell me the bolt size for the ones that hold the running board mounting brackets to the truck body on a 2010 Pathfinder ? Thanks in advance.
Jose
Posted: Tue Oct 22, 2019 3:35 pm
by palmerwmd
Jose,
while I dont have your answer I want to welcome you to the site!
Posted: Tue Oct 22, 2019 6:54 pm
by Paramedic835
palmerwmd wrote:Jose,
while I dont have your answer I want to welcome you to the site!
Thank you very much palmerwmd. Looking forward to learn as much as I can about my new ride.
Posted: Thu Oct 24, 2019 1:08 am
by smj999smj
I remember the older (Gen 1) Frontiers were 10Mx1.25x30. Titans have studs that are 8Mx1.25. You could use an open end wrench to figure out the size of the bolt diameter (hold it up to the hole in the frame). Nissan uses mostly even-sized, Metric sizes, i.e. 8MM, 10MM, 12MM until it gets to the much larger sizes. Then it's just a matter of figuring out the pitch. 10Mx1.25 would be fine pitch and 10Mx1.5 would be coarse, if it's a 10MM bolt. If it's 8MM, it will be 8Mx1.25. For length, 30MM is 1.18-inches.
Posted: Thu Oct 31, 2019 1:37 pm
by ssobol
What about the inserts that go into the running boards? When I took mine off, I found that some of the bolts had seized. Either the bolt would shear off or the whole insert would come out of the running board.