Page 1 of 1

Center console latch.

Posted: Mon Oct 29, 2007 4:03 pm
by BMXPath
I snapped the latch on the armrest center console in half. I am sure I stressed it from leaning on it while reaching across to the glove box or maybe from leaning on it while getting adjusted in my seat.

I took the lid apart and JB welded the latch back together. With it reassembled it looked fine since the break in the plastic was inside where it cant be seen... It lasted about a week til it broke again. :o

Anyone have a solution besides a complete new armrest lid from the dealer for $160?

Posted: Mon Oct 29, 2007 6:28 pm
by phantom2
I don't think there's too much to repair on that latch.How about a junk yard?

Posted: Tue Oct 30, 2007 6:51 am
by BMXPath
I thought about the junk yard. Are there many '05 and later Paths in the junkyard yet?

Posted: Tue Oct 30, 2007 7:56 am
by marked001
www.car-part.com ..invaluable resource..all linked junkyards.. have ordered tons of stuff from yards i've found on here.. good luck.

Posted: Tue Oct 30, 2007 10:31 am
by blink32
Could this possibly be blamed on the TSB out for the center latch console? It may not be applicable now since the application of JBWeld and what not but you never know.

Posted: Tue Oct 30, 2007 3:47 pm
by danny
Try plastic weld, it's made by permatex and available at any auto parts store. Sand the edges to roughen the pieces and glue them together.

Posted: Tue Jan 29, 2008 12:38 am
by Gray
Sounds like it might have been a faulty latch, I think Nissan even has a TSB specifically on those...I'd go check the service managers pulse. :)

Posted: Wed Jan 30, 2008 10:19 am
by Billy T.
Mine broke, literally, the first day I drove the truck.

I just let it be. Might be hard though if you were used to it latching for a few years... I don't know any different, so it doesn't bother me.