ABS SLIP VDC Light
Posted: Fri Sep 22, 2017 9:07 pm
Over the past few years, there have been a few occasions when my ABS, SLIP, and VDC lights have come on. But they've always gone out on their own, and stayed off. Usually this happened when it was really wet or slushy out. I've never done any diagnosis or disassembly to figure it out, as it always seemed to go away.
In the last few weeks, the lights have started coming on and not going out. I don't have an ABS code reader. Is there a way to read these codes without a reader? Or with my ELM327 OBDII reader and Torque app?
Was thinking about pulling the sensors out in the rear to see if they are dirty or if the wires are worn out. I've also read that the steering angle sensor can go bad. Are there any other symptoms that would point to that failure mode?
Thoughts?
In the last few weeks, the lights have started coming on and not going out. I don't have an ABS code reader. Is there a way to read these codes without a reader? Or with my ELM327 OBDII reader and Torque app?
Was thinking about pulling the sensors out in the rear to see if they are dirty or if the wires are worn out. I've also read that the steering angle sensor can go bad. Are there any other symptoms that would point to that failure mode?
Thoughts?