Page 1 of 2

radio wiring diagram

Posted: Mon Jun 15, 2009 8:20 pm
by Bradwm2
hey ive got a 95 pathy unfortunatly the d.a.'s that had it before me cut out the radio harness so all i got is stray wires and i know a lil bit bout radios like the red yellow and black and the speaker wires but idk wat the rest are i used just the red yellow and black and no power wat are the rest of the wires?

Posted: Tue Jun 16, 2009 3:34 am
by blink32
Do you have(or did it originally have) the 2 speaker, 4 speaker or the 6/8 speaker setup? Being a pathy probably a 4 or 6/8 setup but need to know which first. Also do you know the colors that are left? I've got the manual but need to know which setup you have to tell you anything definite. And since the HU upgrade I assume all the other components have been upgraded also?

Posted: Tue Jun 16, 2009 10:53 am
by Bradwm2
i really dont know as far as the setup when i got it it had no radio and no speakers.

Posted: Tue Jun 16, 2009 10:56 am
by Bradwm2
also im starting to think the black red and yellow wires arnet wat they r supposed to be i startin to thing that they are for speakers.

Posted: Tue Jun 16, 2009 4:40 pm
by blink32
Can you look around and see how many factory speaker holes/areas there are? I only press the issue because it matters significantly if there are only locations for 2, 4 or 6/8 speakers. One version had amps one didn't.

I didn't realize you were saying you had those wires. The two speaker system does not utilize any yellow wires nor any solid red wires. Black would go to the speakers. The 4 speaker setup also uses no Yellow nor any solid Red wires. The Black also goes to the rear speakers. With the 6/8 setup there are multiple amps involved and all kinds of different colors.

reply

Posted: Tue Jun 16, 2009 6:10 pm
by Bradwm2
as far as i knw there are only 4 speaker holes 2 6.5s and 2 5x7s there was also a place for tweeters in the pillars so.... and i have a fuse for an amp so there may have been 1 amp

Posted: Tue Jun 16, 2009 6:33 pm
by blink32
If I were in your position I'd just run all new wiring.

Posted: Tue Jun 16, 2009 6:46 pm
by Bradwm2
i know i did that for a lil while but then started to run out of wire but i like a challenge and to lern more about things so i figured id go for it was i wrong ill stiil probably do research and try it again

Posted: Tue Jun 16, 2009 6:49 pm
by blink32
Look around for the Factory Service Manual for it. You'll get a good idea for the color codes for the wires and how many there are and where they run from there.

Posted: Tue Jun 16, 2009 6:52 pm
by Bradwm2
ok apreciate it btw can you give me some help on the other post about the speakers

Posted: Tue Jun 16, 2009 6:59 pm
by blink32
Are you talking about what colors the wires are for the speakers?

Posted: Tue Jun 16, 2009 7:03 pm
by Bradwm2
no im trying to figure out were i can add 2 4x4 speakers

Posted: Wed Jun 17, 2009 2:20 pm
by blink32
Gotcha. I didn't see that other post. I no longer have a D21 chassis vehicle so I can't help you there. Good luck.

Posted: Wed Jun 17, 2009 3:26 pm
by Bradwm2
ok preciate the help

Posted: Fri Jun 19, 2009 8:57 pm
by Bradwm2
hey decided to just run new wires thanx for the help