94 pathfinder stalls after 2 min.
Posted: Sun May 05, 2013 1:45 am
Hope post is not too long, just feel back story may help with solution. Right at 160,000 miles changed timing belt on my beloved 94 pathfinder. while tore down to that point also changed water pump, replaced 2 bent valves(when timing belt broke), front main seal, and of course a full tune up as put back together. ran great for 3 days now runs beautiful for 1-2 min then stalls. then very hard to restart and as engine light comes on it starts but will run very, very rough. did notice that as idle was increased to above 1200 rpm or more it ran a lot longer before it stalled. replaced coil and full distributor(parts warehouse). Also tried new MAF sensor and computer(both ebay) to no fix as of yet. any help or guidance please, I thank anyone.[/b]