How do i remove 2000 pathfinder 3.3L crank pulley?
Posted: Wed Oct 13, 2010 10:58 am
by evoalf
How do i remove 2000 pathfinder 3.3L crank pulley? i I got the center bolt out. What kind of puller do i need to pull the crank pulley out? please help..
Posted: Tue Oct 19, 2010 12:12 pm
by skifiddle
My 98 has two jack screw holes tapped through. I would guess 6mm. I am going to measure. 2-1/2 in long to reach into pulley. I thought they were for a puller but then it started off when I was lubing the holes. Just like some brake drums.
I have an AT. I tightened by belts to where I couldn't wiggle them and clamped strips of wood to the two large belts with two small c-clamps each so they were hitting solids. Then able to do the bolt. Beats pulling the starter, renting air, etc.