Postby Tech » Mon Oct 26, 2009 10:53 am
With the first replacement, there will be no nut (bolt actually). Directly behind the glove box, you will see a horizontal cover, about 1-1/2 inches high, maybe 6" across, at the top of it will be a little tang holding it in place, at the bottom 2 (i think) tongues that slide into reciever holes. You have to gently lift up on the upper tab and pull the top of the cover out towards you, then out of the lower holders. What every one is talking about is that upper tab, it's sometimes easy to break off. If it breaks, don't sweat. Look to the upper left of the cover/box. You will see a slot that lines up to a hole on the cover. Should you break the tab off or bend it so there's insufficient tension, you can add a speed-nut and bolt. If you run the heater for a while or park indoors, you have a better chance of not breaking it, but its no gaurantee. The filter is a 2 parter, make sure the first half goes in all the way and over all the way or you'll end up with a gap..you'll see....it sounds way worse than it is...go for it.