Transfer case leaking ? Or toast ?
Moderator: volvite
Transfer case leaking ? Or toast ?
I was looking under that pathy and I noticed that there were a few drips on the floor near the middle of the truck. I looked and the transfer case and I notice fresh fluid drips from the entire bottom if it. Looks like a seal might have gone bad. Has anyone experience this ? Could it be something more sinistar like the transfer case going out ?I still have my powertrain warranty so I am taking it to the dealer, but I am a bit surprised that this would happen out of the blue all of a sudden. This is a full-time AWD equipped LE. I took the pictures after wiping it off, figured I could check again in the morning. But basically the area where the two parts of the case are ajoined at the bottom is where I saw the fluild built up and dripping off of. I also noticed on the front driveshaft that it is partially discolored, as if it was wet or got oil on it.
Last edited by kev1n on Sun Nov 15, 2009 9:32 pm, edited 1 time in total.
Ok, I couldn't let sleeping dogs lie, so I went back again to look at and take more pictures. It looks like the leak is more like a "spray" there is fluid all over and it looks to be a radial pattern, I saw some on the underbody above the front driveshaft. So I am thinking this might be the coming from the front driveshaft where it connects to the front end of the case. any thoughts ?
How safe is it to drive with this condition ?
How safe is it to drive with this condition ?
That's where I'd guess. It would be called the front output shaft seal. You can drive it, but it's just going to get messier before if it gets replaced. Mine leaked on my old Wagoneer and I never fixed it as everything else leaked, too. Of course, make sure it's not dripping from even higher up and falling onto shaft.
here's a great leakage diagnosis method:
degrease, clean, and THOROUGHLY dry the suspect area
spray white footpowder (aerosol) onto the suspect area
monitor the area carefully
if the leak is there, it will become visible as the liquid sweats out into the coating of dried powder
hope this helps..........
good luck with your search & please let us know what you find!
degrease, clean, and THOROUGHLY dry the suspect area
spray white footpowder (aerosol) onto the suspect area
monitor the area carefully
if the leak is there, it will become visible as the liquid sweats out into the coating of dried powder
hope this helps..........
good luck with your search & please let us know what you find!
Yes I do, there is a breather on the t-case that allow the t-case to breath when it gets hot. This way the heated air can excape and relieve the pressure off the seals, when you stop driving the air cools down and gets dence creating a low pressure and allows the air to come back in. If the breather is clogged up the heated air expands and the case becomes pressurized. The pressure then finds the weakest link (seals) and pushes the fluid out.kev1n wrote:
Anyone know anything about the breather cap thing ?
Did this help?
I haven't seen the one on the PF personally, but the breather is usually on the top of the case. It is usually a little tube, maybe 5/16 or so. If Nissan did it right, then they put a hose on the tube that runs high into to the engine compartment so no water gets in during deep water crossings.
Like I said, I haven't spied it on the PF myself, but you may want to crawl under there with a small mirror so you can see the top of the t-case and see what you find.
Like I said, I haven't spied it on the PF myself, but you may want to crawl under there with a small mirror so you can see the top of the t-case and see what you find.
Find Your Forum!