Should the engine remain on after step 4 for the revving that takes place in steps 5a-b and 6?pawjr74 wrote:If you clean the throttle body you'll have to go through this re-learn proceedure.
----- IDLE AIR VOLUME LEARNING -----
(The following steps are very time critical and any errors in timing may cause the malfunction indicator lamp to illuminate. If this occurs, you need to reset the ECU and complete all of the tasks again)
1. Start engine and warm it up to normal operating temperature.
2. Check that all items listed under the topic PREPARATION (previously mentioned) are in good order.
3. Turn ignition switch OFF and wait at least 10 seconds.
4. Confirm that accelerator pedal is fully released, then turn ignition switch ON and wait 3 seconds.
5. Repeat the following procedure quickly five times within 5 seconds.
5-a. Fully depress the accelerator pedal.
5-b. Fully release the accelerator pedal.
6. Wait 7 seconds, fully depress the accelerator pedal and keep it for approx. 20 seconds until the MIL stops blinking and turned ON.
7. Fully release the accelerator pedal within 3 seconds after the MIL turned ON.
8. Start engine and let it idle.
9. Wait 20 seconds.
12. Rev up the engine two or three times and make sure that idle speed and ignition timing are within the specifications. The vehicle should idle at 625 RPM's.