Moderator: volvite
Here it is in action on my B&M external cooler thread...volvite wrote:I've been looking into the bullydog, but don't remember the trans temp. I guess I need to go back and do some reading again.
Easier said than done on the Pre-Cat sensors. Unless you have way smaller hands than me. The only way for me to get the pre-cat sensors out was to destroy the connector, its got a push-grommet on it, and its impossible to get the needlenose pliers in there to disengage the gromment... Hope you have better luck than me!NYPathfinder wrote:I guess i'll go ahead and change the sensor or swap the sensor from one bank to the other to see if the low voltage follows that sensor.
I'm 6'5 280. so i doubt my hands will fit in there lol. i guess if its that much of a pain ill do it once and replace it and not have to deal with it again for quite a while. I may give my friend a few buck to do it. He's small and has arms the size of a 12 yr old.. he should fit.disallow wrote:Easier said than done on the Pre-Cat sensors. Unless you have way smaller hands than me. The only way for me to get the pre-cat sensors out was to destroy the connector, its got a push-grommet on it, and its impossible to get the needlenose pliers in there to disengage the gromment... Hope you have better luck than me!NYPathfinder wrote:I guess i'll go ahead and change the sensor or swap the sensor from one bank to the other to see if the low voltage follows that sensor.
See my writeup here:
http://www.thenissanpath.com/viewtopic.php?t=5280
Note that the user "found" also posted a bench test procedure for the sensors. I couldn't get it to work, but to be honest, didn't really try that hard...
t