Super Strange Issue

Attack of the unibody snatchers! Styling and handling refined or bland? You decide.

Moderator: volvite

01PathLE
Posts: 36
Joined: Mon Feb 13, 2012 11:32 am
Location: Guyton, GA

Super Strange Issue

Postby 01PathLE » Wed Jul 15, 2015 10:25 am

I know this is going to sound strange, but this is exactly whats happening. It takes forever to go into drive. Fluid is clean and at the level its supposed to be. At first I thought it was doing it when it was cold, but it does it when its warm/hot too. It goes into reverse fine. And will normally engage pretty quick if I put it in 1st. Here's the strange part. If it has a full tank of gas, it goes into drive fine. Once it gets to half a tank or less, it starts not wanting to go into drive. Wtf??? Could the weight of a full tank be pressing on a wire or something and then with less weight not be making good contact or something? I'm stumped! Its a 2001 LE 2WD.


01PathLE
Posts: 36
Joined: Mon Feb 13, 2012 11:32 am
Location: Guyton, GA

Postby 01PathLE » Fri Jul 17, 2015 5:31 am

Anyone?

starman8tdc
Posts: 55
Joined: Sun Apr 26, 2015 11:20 am

Postby starman8tdc » Fri Jul 17, 2015 9:21 pm

Did you try changing the trans filter? Proper length dip stick?

01PathLE
Posts: 36
Joined: Mon Feb 13, 2012 11:32 am
Location: Guyton, GA

Postby 01PathLE » Wed Jul 22, 2015 4:59 am

Haven't done the trans filter yet. Dipstick is right. Its just so strange that its fine with a full tank of gas.

starman8tdc
Posts: 55
Joined: Sun Apr 26, 2015 11:20 am

Postby starman8tdc » Wed Jul 22, 2015 12:20 pm

When the tank is around 1/4 full, try loading a bunch of weight into the back of the rig, in order to simulate a full tank of gas. 1 gallon of gas weighs around 8 pounds. Does it go into gear better when on a steep incline? If the vehicle is rolling forward, will it go into gear easier? Pinched tranny cooler lines?

01PathLE
Posts: 36
Joined: Mon Feb 13, 2012 11:32 am
Location: Guyton, GA

Postby 01PathLE » Mon Aug 10, 2015 1:53 pm

Haven't tried adding weight yet. Incline doesn't matter. Rolling doesn't matter. Cooler lines look fine. If I put it all the way down in first it will sometimes go fine, but if I move it up to drive theres nothing.

starman8tdc
Posts: 55
Joined: Sun Apr 26, 2015 11:20 am

Postby starman8tdc » Mon Aug 10, 2015 3:12 pm

The vapor recovery for the fuel system works on engine vacuum. Some vehicles have vacuum lines that help control the transmission. That's the only link between those components I see other than electrical, which would be scary. If you have a vacuum line problem, it would be effected by the fuel level, thus disabling the trans.

Unlikely that this is your cause, but it an unlikely problem that you have, so....

01PathLE
Posts: 36
Joined: Mon Feb 13, 2012 11:32 am
Location: Guyton, GA

Postby 01PathLE » Fri Oct 16, 2015 6:28 am

starman8tdc wrote:The vapor recovery for the fuel system works on engine vacuum. Some vehicles have vacuum lines that help control the transmission. That's the only link between those components I see other than electrical, which would be scary. If you have a vacuum line problem, it would be effected by the fuel level, thus disabling the trans.

Unlikely that this is your cause, but it an unlikely problem that you have, so....
What/where would I check for this?

starman8tdc
Posts: 55
Joined: Sun Apr 26, 2015 11:20 am

Postby starman8tdc » Fri Oct 16, 2015 12:32 pm

Not sure on what you would check on the vacuum lines. Check your service manual to see if there is a vacuum line to the trans, and trace it maybe. Have you tried resetting the computer by disconnecting the negative battery cable overnight?


Return to “1996-2004 Pathfinder (R50)”