Steve,
I am going to assume that the '08 is similar to an '05 on interior design. With that in mind, here are pics of how to do it. I hope this helps you.
First, you remove the little storage tray on top, above the radio. It snaps in with built in clips on all four corners. Gently pry up on it until the clips pop loose, as shown.
Remove the phillips screw in the center, from where you removed the tray, above the radio.
Gently pull out just the top portion of the console panel that is below the radio and goes around the shifter. It clips in too. You dont have to remove the entire console/ shift trim panel, just pull it out enough to make clearance for the lower lip of the radio/ ac trim panel... as shown in the picture.
The radio/ ac trim panel is also held in by clips. Pull it out. You should be able to remove it by hand, without prying.
As you pull out the whole panel, pay attention to the wires attached. The wires are for a/c controls, and your passenger air bag indicator. There may be other wires, depending on your Pfinders options.
You can unplug them, but be aware that your airbag light may need to be reset if you do. If you can get the panel out of the way enough for your needs, without unplugging the wires, it would probably be better.
There are four phillips screws holding in the radio bracket that holds the radio. Remove the screws. The radio assembly will come out now.
From this point. you said you knew the wiring. Good luck, have fun. Post pics when you are done.
