

Moderator: volvite
Well, this particular vehicle was one that had been at a GM dealer and was being worked on by a friend of mine, who sent me the pics. It has just been sold to a customer and I'm not sure where they got it from. Obviously, they didn't want to throw a lot of money into it. Interestingly, while the #2 bank, upper tensioner was worn to the point of the chain cutting into the tensioner plunger, he said there was no apparent damage to the valves or other cylinders on the bank. They ended up pulling the engine and replacing the #2 piston w/ rings, rod and rod bearings. Also, the oil pump, water pump, and the full timing set. There was a minor scratch on the combustion wall which is was pretty much able to get out with a little honing. The engine was put back together and I hear it's running fine! What the cost was, I don't know, but, apparently the dealer thought it was the cheaper route compared to the cost of a used engine, which they priced at $1700.Kestral wrote:SMJ is that even worth fixing or would it be better at that point to short block it? I would bet rebuilding a VQ40 is not cheep?