*The floor cover does go back down and locks with this installed. If you look at the last pic, I just relocated the tire tools to the jack area, it all fits nicely.
1. Pull straight up to remove the plastic kick plate where the rear hatch locks.

2. Drill your holes through the safe and plastic pan. Pull the pan up and run your bolts through the bottom. I used fender washers under the plastic, between the safe and plastic and under the nut inside the safe.

3. Put the safe over the bolts, put nuts on and tighten securely.

4. Snap the plastic kick plate back into place and you are all done!
