As of today
I have ordered all of the necessary parts and they will be on the way.
I am basically rebuilding my entire front and rear suspension.
Here is what im replacing
Front:
Lower Control arms
Moog Camber/Caster Bolts
Moog Quick Struts with a 2 inch lift spacer
Rear:
Lower Control Arms
Moog Camber Bolts
PRG Sway Bar End Links (you gotta get these!)
Some of my parts have arrived this week ( see post below)
I saw that someone mentioned that the rear didn't have adjustable camber bolts for the control arms. I did some investigating and I found something interesting:
Facing towards the front of the vehicle (non adjustable bolt)
![Image](https://i.imgur.com/JOi8f1Il.jpg)
Facing the rear of the vehicle (adjustable camber bolt)
![Image](https://i.imgur.com/RFXXaqFl.jpg)
Is this normal to have on rear lower control arms? I usually see either both camber bolts or both non adjustable bolts. Not 1 of each.
I mentioned im getting PRG end links. If you do a lift, you need these!
Here is one installed on the drivers side on my pathfinder.
![Image](https://i.imgur.com/m5ZuemTl.jpg)
These end links are length adjustable. You can adjust them so they can better handle your vehicle setup.