Removing dash trim

**** PLEASE USE SUBTOPICS BELOW FOR NEW TOPICS ****

Moderator: volvite

User avatar
thejean
Posts: 52
Joined: Sun Sep 21, 2008 4:47 pm
Location: Calgary, Alberta

Removing dash trim

Postby thejean » Fri May 15, 2009 4:00 pm

Hello, looking for some advice on how to go about removing the dash pieces so I don't wreck any of the little snap clips that I am sure are holding the panels in place. Thanks and cheers! JC


User avatar
thejean
Posts: 52
Joined: Sun Sep 21, 2008 4:47 pm
Location: Calgary, Alberta

Postby thejean » Sun May 17, 2009 1:29 pm

Well, I twisted, pryed and put the truck in N to be able to get the center console piece out. Eventually got it out of the way enough to get the job done. I gotta ask though, how the heck do you get the centre trim over the shift knob? For life of me I couldn't figure it out.

User avatar
bwareheim
Posts: 99
Joined: Thu Jan 01, 2009 11:38 pm
Location: Baltimore, MD

Postby bwareheim » Sun May 17, 2009 7:20 pm

i turn the car on but not the engine. i make sure i have the e brake on then i put it into drive or the lower gears this will give you enough room to pull it off


Return to “2005-2012 Pathfinder (R51)”

cron